Pg 2
Machine Specifications (For Reference)
•
Set your max temperature 5 degrees below the maximum firmware
limit to prevent a “MAXTEMP” error.
•
This machine includes sensitive wiring and hardware. It should be kept
in a well ventilated and dry environment. Humidity can have adverse
or negative affects on the printer and should be avoided.
•
This printer includes parts which can exceed 350C and caution should
be taken. Do not let pets or children near the product without supervi-
sion. Let the hotend cool down 10 minutes before touching it.
•
Always keep a working fire extinguisher and have a working smoke
alarm near the printer. Never place flammable objects near the printer
including liquid chemicals that can release flammable vapors.
•
Never open the electronics case when the printer is powered on.
•
Any modifications or attempted repairs, not explicitly directed by
gCreate, that cause damage are not covered under the Warranty
Max Hotend Temperature
(Do not set above)
350C ( All-Metal) 450C Compaable
Filament Diameter 1.75mm
Layer Height Range
(Suggested)
0.080mm - 0.740mm
(Nozzle Dependent)
Electronics
Power
SKR v2, STM32 32-bit (Arm Cortex M4)
Heated Bed 120C MAX TEMP
Firmware Marlin 2.0 (gCreate Modified)
120V - 240 V (Selectable)
Warning
To Next Page
Loading...
