To Next PageTo Next Page
Need help?Do you have a question about the GDS 630L series and is the answer not in the manual?
General| Brand | GDS |
|---|---|
| Model | 630L series |
| Category | Gate Opener |
| Language | English |
Details on power supply, conduits, and wiring for gate operator and accessories.
Instructions for gate movement, concrete base, gate stops, and rack/pinion alignment.
Wiring mains voltage, low voltage, and limit switches to the operator and control board.
Instructions for connecting the 240v power supply and earth to the control board.
Guidance on connecting shielded motor cables to inverter terminals and earth.
Details for connecting limit switch wires and the common terminal.
Explanation of normally closed/open inputs and the use of IM-1 modules for isolation.
Information on powering 24v AC accessories from the transformer output.
Wiring for electric locks and lights using output terminals and relay modules.
Procedure for adjusting pre-set cycle and auto-close times using dip-switches.
Configures motor start delay between Motor 1 and Motor 2 for synchronized operation.
Determines if the lock output is active for the entire cycle or pulses at the start.
Controls optional light module for timed lights or warning lights.
Defines the behavior of the OSC input for gate operation and auto-close reset.
Sets M2 output function for controlling a second motor or status lights.
Defines how Photo Electric (P.E) input affects closing cycle (reverse or stop).
Defines how Photo Electric (P.E) input affects opening cycle (ignored or stop).
Enables auto-close mode triggered by P.E input activation and release.
Enables auto-close mode for pedestrian access with a 15-second delay.
Enables standard auto-close mode after fully opening, with a 30-second delay.
Setting VSD accelerate (FN01) and decelerate (FN02) times for smooth operation.
Adjusting closing (FN08) and opening speeds via frequency settings.
