2Ć2
GFKĆ1029BLogicmaster 90Ć30 and Logicmaster 90Ć70 TCP/IPĆEthernet User's Manual Supplement-April 1996
To install and run Logicmaster 90Ć30 TCP/IP or Logicmaster 90Ć70 TCP/IP software, the
computer must meet the following requirements.
DOS Version 5.0 or later
80386, 80486 or Pentium computer
8.5 Megabytes of available space on hard disk for Logicmaster and Beame &
WhitesideĆConnect TCP products
2 Megabytes of RAM
600 Kilobytes (614,400 bytes) of Free Conventional Memory. To determine this value
for your personal computer, execute the DOS command after completely
installing the software package and rebooting.
Diagnostics disk from Ethernet interface vendor (Direct Ethernet Connection only)
Refer to GFKĆ1084, TCP/IP Ethernet Communications User's Manual for configuration
information.
&# !" " !" ' " " !"$
" !" " " % # " " !"" The
Quick Start Installation Program installs Logicmaster 90Ć70 software,
Beame & Whiteside software for direct Ethernet communication, and
the GSM software.
The GSM is used to configure the TCP/IP Ethernet Interfaces installed in the Series 90Ć70
PLCs on the network. This must be done before Logicmaster 90Ć70 software can
communicate with the PLCs. The operation of the the GSM is described in GFKĆ1004,
TCP/IP Ethernet Communications User's Manual. Refer to appendix A of this manual
(GFKĆ1029) if you are installing the GSM software on the same PC as Logicmaster 90Ć70
software. Refer to GFKĆ1004 if you are installing the GSM software on a separate PC.
If you are updating Logicmaster 90Ć70 Software or the Beame &
Whiteside software, refer to the instructions in this chapter. If you are
updating the GSM software, refer to GFKĆ1004 for instructions.
To Next Page
Loading...
Need help?
General
