GE Interlogix ATP1000 - User Manual

1
,QVWDOODWLRQ,QVWUXFWLRQV
ZZZ*(,QWHUORJL[FRP
*(,QWHUORJL[
'
Product
Summary
The ATP1000 lets you control all programming and operation of compatible security systems
(see the “Specifications” section).
The large 2-line, 16-character display provides easy to read messages to indicate the current sta-
tus of the system. The touchpad includes police, fire, and auxiliary panic buttons that can be acti-
vated anytime. A built-in speaker provides alarm, status, and button-press sounds. A swing-
down door reveals a label with basic system operating commands. The door can be removed by
simply opening it past its stop point. The door can also be reattached later if desired.
Tools and Equipment Needed
• 4-conductor, 22- or 18-gauge wire
• Screwdriver
• #6 screws and anchors (included)
• Panhead screws for gang box installation
• Saw or utility knife for cutting wallboard
Installation Guidelines
• Mount the touchpad in an environmentally controlled area (32°F to 120°F/0°C to 49°C).
• When mounting the touchpad, allow at least 3 inches below it for the swing-down cover.
• Do not exceed the maximum available power. See the panel installation instructions for max-
imum available power.
• Table 1 describes the power used by the touchpad.
• Table 2 describes the maximum wire lengths allowed between the touchpad and the panel.
Table 1: Touchpad Power Usage
Current (mA) Conditions
110 Maximum alarm current with the
buzzer sounding and the touchpad
illuminated from a button press
60 Typical operation
12 Power saving mode (no panel AC
power)
Table 2: Maximum Touchpad Wire Lengths
Wire Gauge
(Unshielded or
Shielded)
Max. Touchpad Wire Length
Between Touchpad and Panel
18 750 feet
22 300 feet
'RFXPHQW1XPEHU5HY$
2FWREHU
$737RXFKSDG'LVSOD\
0RGHO1R

Summary

Product Summary

Tools and Equipment Needed

Installation

Installation Guidelines

Guidelines for mounting the touchpad in an environmentally controlled area and power considerations.

Installing the Mounting Plate

Steps to separate the touchpad and mount the plate on the wall for installation.

Wiring the Touchpad to the Panel

Instructions for connecting the touchpad wires to the security system panel.

Attaching the Touchpad to the Mounting Plate

Steps to connect the touchpad to its mounting plate after wiring is complete.

Power Up and Bus Communication

Connecting the Touchpad for System Programming Only

Testing

Adjusting Display Brightness and Contrast

Troubleshooting

Changing the Touchpad Unit Number

Guidelines for changing touchpad unit numbers to avoid communication conflicts.

Specifications

Notices

GE Interlogix ATP1000 Specifications