To Next Page

To Previous Page

Lift

Latch

HOW TO Prepare The Carpet Shampooer/

Extractor For Carpet Cleaning

IMPORTANT: For best results, begin with a clean surface by vacuuming surface or item before using the

carpet shampooer/ extractor.

A. Fill the Clean Water Solution Tank

1) Lift up the tan k latch to release the clean water solution tan k.

2) Grasp the carrying han dle on th e clean water solution tank and

remove it from unit.

3) Remove cap and add 4 ounces of Genuine GE carpet/ uph olstery

sh ampoo to the tank.

4) Fill tank to the designated fill line with warm tap water, not to

exceed 120°F, replace cap (see diagram).

5) Place clean water solution tank into the carpet shampooer/

extractor unit by

a) place the bottom of tank into the reservoir.

b) gently push upper portion of tank into unit until it snaps

securely in to place.

Fill Line -

1 Gallon

NOTE: When moving the carpet shampooer/ extractor from one location to another, always make sure th e

recovery and clean water solution tan ks are completely empty. Then tilt the unit slightly backward and

roll on rear wheels or use the carpet shampooer/ extractor’s carrying handle for transporting up and

down stairs.

NOTE: Mix cleaning solution properly to avoid

damage to carpet and upholstery.

NOTE: FAMILIARIze yourself with the parts of the

carpet shampooer/ extractor by reading this

owner’s manual before using.

Carrying

Handle

Tank Latch

GE 106727 User Manual

Questions and Answers: