Preparing to install the refrigerator.
17
Troubleshooting TipsInstallation Instructions Customer ServiceOperating InstructionsSafety Information
Read these instructions completely and carefully.
Water Supply to the Icemaker
(on some models)
If the refrigerator has an icemaker, or if you plan to add an
icemaker later, it will have to be connected to a cold water line.
A water supply kit (containing copper tubing, shutoff valve, fittings
and instructions) is available at extra cost from your dealer or from
Parts and Accessories, 800-626-2002.
Do not install the refrigerator where the temperature will go below
60°F. (16°C.) because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Refrigerator Location
Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
Sides 3/4″ (19 mm)
Top 1″ (25 mm)
Back 1″ (25 mm)
Clearances
To Next Page
Loading...
