Installation Instructions
[] REMOVE THE FRESH FOOD
DOOR
8.1 Tape the door shut with masking tape.
[]REMOVE THE FRESH FOOD
DOOR (CONT.)
3.4 Set the door outside-up on a non-scratching
surface.
3.2 Using a 5 16" hex-head socket screwdriver and
a 5/16" open-end wrench, remove the two
screws holding the center hinge {and the shim
glued to it} to the cabinet. Lift the center hinge
to free its pin from tim socket in the top of the
door. and set hinge and screws aside. Be careful
not to lose the center hinge spacer and washer.
3,3 Remove the tape and tilt the door away from the
cabinet. Lift the door from the pin in the bottom
hinge bracket. (If the plastic washer sticks m the
door bottom, put it back on the hinge,)
3.5 Using a Torxdrivel; transfer the two screws from
the opposite side of the cabinet to the screw holes
vacated by the center hinge removal.
/
3.6 Transfer the washer (if'your model has one) to the
opposite side.
3.7 Take one of the screws removed in step 2 and start
it in the outermost screw hole on the opposite s!de:
Do not drive it all the way down-leave enougb
space under the screw head fbr thichmss of shim
and bracket,
I/
o
21
To Next Page
Loading...
Need help?
General
