PROBLEM
SOLWR
(continued)
PROBLEM
HOT
AR
FROM
BO~OM OF
REFRIGERATOR
DOOR NOT CLOSING
PROPERLY
FRESH
FOOD OR
FREEZER COMPARTMENT
TEMPERATURE
TOO WARM
FOODS DRY OUT
FROST
OR
ICE
CRYSTALS ON
FROZEN FOOD
SLOW ICE CUBE
FREmme
ICE CUBES HAVE
ODOWTASTE
AUTOMATIC
ICEMAKER
DOES NOT WORK
(on some models)
CUBE DISPENSER
DOES NOT WORK
(on some models)
POSSIBLE CAUSE
●
Normal
air flow cooling
motor.
In
me
refrigeration process, it is normal that heat
be expelled in the
area
under
the
refrigerator,
Some
floor coverings will discolor
at these
norrn~
and safe operating
temperatures.
Your floor covering supplier
should be consulted if
you
object
to
this
discoloration.
*
Door gasket
on
hinge
side
sticking or folding over. To correct, put a small
amount of petroleum jelly on face of gasket.
●
Temperature control not set cold enough. Refer to Temperature Control section.
●
Warm weather-frequent door openings.
●
Door left open for
long
time,
●
Package may be holding door open.
●
Foods
not
covered, wrapped or soled properly,
* Door may have been
left
ajar or package holding door open.
s
Too frequent or
too
long
dmr
openings.
*
Frost within package is
norrnd.
●
Door may
have
been left open.
●
Turn temperature
of
freezer compartment colder.
Q
Old cubes need to be discarded.
●
Ice storage bin needs to be emptied and washed.
* Unsealed packages
in
refrigerator andor freezer compartments may be
transmitthg
odoritaste
to
ice
cubes.
●
Interior of refrigerator
needs
cleaning-refer
to
Care
and Cleaning section.
●
Poor-tasting incoming water.
Instrdl
a water filter-see Water Filter
Accessory section.
●
ON-STOP control
h
STOP (up) position.
●
Water supply turned
off
or not connected.
●
Freezer compartment too warm.
. Cubes too small—water shutoff
v~ve
connecting refrigerator to home
water line may be clogged.
●
Sometimes cubes fuse
to
the
side
of
the
ice mold and hold the feeler arm in the
STOP
(up)
position.
Remove
MS
ice to restart the icemaker.
●
When reaching for
cubes
by
hand,
you
may
have
pushed the feeler arm into the
STOP (up) position by mistake.
●
Piled up cubes in storage
bin
may
cause
icemaker
to
shut off
too
soon.
With
icemaker feeler arm
in
STOP
(up)
position, level cubes in
bin.
c
No ice
cubes,
Remove storage container.
E
cubes
are
fimn
to wire arm,
remove cubes.
Q
No ice cubes.
Icemaker
turned off
or
water supply turned off.
●
Irregular
ice
clumps
in
storage container,
Breti
up as many as you can with
fingertip pressure and
discmd
the remaining clumps.
18
To Next Page
Loading...
Need help?
General
