GE 19 Use And Care Guide

REVERSE HARDWARE OH CABINET
J. Remove the base grille, if your refrigerator has
one (see page 3). Grasp it at the bottom and pull it
straight out.
16
PLASTIC
WASHER
49,
\
4
4’\ ‘IL.
‘\b
%
BOITOM RIGHT
b. Using aT20 Torxdriver, remove the hinge (and
shim glued to it) and plastic washer from the
bottom right side of the cabinet.
PLASTIC
——————_
—
c. Reinstall the hinge (and shim glued to it) and
plastic washer to the bottom left side of the cabinet.
/’-
❑ TRAHSFERCEHTERHINGE BRACKET TGTHE LEFT.
DO NOT REMOVE
I
THIS SCREW
I
a. Remove the hinge bracket (and shim glued to
it) from the center right side of the cabinet by
removing the three outermost Torx screws.
b. Remove the three outermost Torx screws from
the center left side of the cabinet and screw them
into the holes at the right side uncovered in Step (a)
above.
DO NOT REMOVE
II
CENTER LEFT
THIS SCREW
/
Place the center hinge bracket over the holes at the
center left side of the cabinet, insert the screws you
removed from the opposite side, and tighten them.
❑ TRANSFER TOP HINGE TO THE LEFT.
Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten
screws on hinge side at this time.
❑ TIMNSFER DOOR-
a. On each door, move the
metal door stop from the
right end to the left end.
,, T
b. Move any screws from
the left end to the right end.
Y
—
(continued next page)
21

GE 19 Specifications

General

Brand	GE
Model	19
Category	Refrigerator
Language	English