To Next Page

To Previous Page

Performance Data Sheet

Hotpoint

Filtration by GE SmartWater

HXRT Cartridge

Performance Tested to NSF/ANSI*

(100% safety factors built in for unmetered usage)

Standard No. 42: Aesthetic Effects

Parameter USEPA Influent Effluent % Reduction

MCL Challenge Average Maximum Average Minimum

Chlorine — 1.96 ppm 0.30 ppm 0.44 ppm 85 78

T & O ——————

Particulate** — 2296 62 116 97.3 94.9

* Tested using a flow rate of 0.5 gpm; pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 20° ± 2.5°C

** Measurement in Particles/ml of 10µ Particles

Operating Specifications

■ Capacity: certified for up to 250 gallons (946 L)

■ Pressure requirement: 40–120 psi (2.8–8.2 bar), non-shock

■ Temperature: 33°–100° F (0.6°–38° C)

■ Flow rate: 0.5 gpm (1.9 Lpm)

General Installation/Operation/Maintenance Requirements

■ Flush new cartridge at full flow for 60 seconds to purge out trapped air.

■ Replace cartridge when flow becomes too slow; at least every six months.

Special Notices

■

Installation instructions, parts and service availability, and standard warranty are included with the product when shipped.

■ This drinking water system must be maintained according to manufacturer’s instructions, including replacement of filter

cartridges.

■ Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after

the system.

■

The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.

■ Check for compliance with the state and local laws and regulations.

GE 19 Owner's Manual

Other manuals for GE 19