8
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation
Instructions
About the refrigerator doors.
Refrigerator Doors
The refrigerator doors may feel different
than the ones you are used to. The special
door opening/closing feature makes sure
the doors close all the way and are
securely sealed.
When opening and closing the door, you
will notice a stop position. If the door is
opened past this stop point, the door will
remain open to allow you to load and
unload food more easily. When the door
is only partially open, it will automatically
close.
The resistance you feel at the stop
position will be reduced as the door
is loaded with food.
When the door is only partially
open, it will automatically close.
Beyond this stop the door will
stay open.
Door Alignment
If doors are uneven, adjust the refrigerator
door.
Using a 7/16″ socket wrench, turn the
door adjusting screw to the right to
raise the door; to the left, to lower it.
(A nylon plug, imbedded in the threads
of the pin, prevents the pin from
turning unless a wrench is used.)
After one or two turns of the wrench,
open and close the refrigerator door
and check the alignment at the top
of the doors.
To remove the
base grille, open
the doors, remove
the screw at each
end of the base
grille and then
pull the grille
straight out.
7/16″ Socket Wrench
Raise
To Next Page
Loading...
Need help?
General
