Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
PUT THE REFRIGERATOR IN
PLACE
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
´ > PP@ IURP WKH IORRU
• Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23’ (33” wide),
25’, 28’ models:
• Turn the roller adjusting screws clockwise
to raise the refrigerator, counterclockwise to
ORZHU LW 8VH D ´ KH[ VRFNHW RU ZUHQFK RU
an adjustable wrench.
4
5
Rollers
Raise
Roller adjusting screw
LEVEL THE DOORS
Adjust the refrigerator door to make the doors
even at the top.
To align:
8VLQJ D ´ ZUHQFK WXUQ WKH GRRU DGMXVWLQJ
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads of the
pin, prevents the pin from turning unless a
wrench is used.
After one or two turns of the wrench, open
and close the refrigerator door and check the
alignment at the top of the doors.
6
A
B
'RRUV VKRXOG EH HYHQ DW WRS
Raise
´ ZUHQFK
LEVEL THE REFRIGERATOR
(cont.)
To adjust the
rollers on 23’/25’
CustomStyle
™
models:
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower LW 8VH D ´ KH[ ZUHQFK ZLWK H[WHQVLRQ
or an adjustable wrench.
These models also have rear adjustable
rollers so you can align the refrigerator with
\RXU NLWFKHQ FDELQHWV 8VH D ´ KH[ ZUHQFK
with extension to turn the screws for the rear
rollers—clockwise to raise the refrigerator,
counterclockwise to lower it.
5
Roller adjusting screws
INSTALLATION INSTRUCTIONS
49-1000471 Rev. 2 27
,
To Next Page
Loading...
Need help?
General
