About the controls on the refrigerator.
10
Operating Instructions
Installation Instructions
Safety InformationTroubleshooting TipsCustomer Service
All panel lights come on for five seconds, a beep sounds, and lights
go off except as follows:
■
PF
flashes in the display. Touch
SYSTEM CHECK-RESET
pad to
erase it.
■ Word
NORMAL
glows.
■ Red
WARM TEMP
light glows if freezer compartment
temperature is higher than normal. It goes off when proper food-
keeping temperature is reached.
■ Door alarm beeper is activated and light on
DOORALARM
pad glows.
■
CRUSHEDICE
selection light glows.
■ Red
DOOR OPEN
light flashes if either door is open, goes
out when doors are shut.
■ Night light in ice and water dispenser is off.
When Your Refrigerator is First Plugged In
How to Set the Door Alarm
You don’t have to set the visual alarm. As long as either
door is open, the red
DOOROPEN
signal light flashes.
If the signal light on the
DOORALARM
pad is glowing,
the beeper alarm is set. If it’s not, touch the pad to turn
it on.
If either door is open for more than 30 seconds, a
recurring beep sounds.
The light goes out and the beeping stops when you close
the door.
There are times when you’ll want the door alarm beeper
turned off. When you’re rearranging a lot of food, for
example, just touch the pad. The light will go out and
the beeping will stop.
Deactivating the door alarm beeper does not turn the
red
DOOROPEN
light off—it keeps flashing until the door
is closed.
To Next Page
Loading...
Need help?
General
