The Electronic Monitor and Diagnostic System monitors the operation of
your refrigerator and controls dispenser functions.
Troubleshooting TipsInstallation Instructions Customer ServiceOperating InstructionsSafety Information
1 2 3 4 5
6 6 7
Electronic Monitor and Diagnostic System
Lighted word
NORMAL
indicates that no failure has been
detected by the diagnostic system.
DOOROPEN.
Red signal light flashes to tell you when
either door is open.
WARMTEMP.
Red signal light tells you when freezer food-
keeping temperature is above normal.
Flashing diagnostic codes in the display warn you when:
frozen foods should be checked.
power has been interrupted.
icemaker may not be operating properly.
defrost system has failed.
What these codes mean—and what to do when
they appear—is explained more thoroughly on the
following pages.
SYSTEM CHECK-RESET
pad puts a review of the electronic
diagnosis of four coded functions at your fingertip and
also allows you to erase codes from display.
Electronic control allows you to select
CUBED ICE,
CRUSHED ICE
or
CHILLED WATER
and signal light confirms
your choice.
Signal light tells you that the
DOOR ALARM
beeper has been
set to sound after either door has been open 30 seconds.
9
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
