About the controls on the refrigerator.
12
Operating Instructions
Installation Instructions
Safety InformationTroubleshooting TipsCustomer Service
How the Electronic Monitor and Diagnostic
System Works
The electronic monitor and diagnostic system alerts you
when something starts to go wrong.
If a diagnostic code appears on the display, something
needs special attention. To get your attention, the
display code flashes until you erase it. The first 6 flashes
are accompanied by beeps.
If more than one coded function requires attention at
the same time, the one with the highest priority will be
displayed first.
Pressing the
SYSTEM CHECK-RESET
pad will evaluate all
other coded functions. If the
NORMAL
display is lit
during the displaying of a code, that function is
operating properly.
Pressing the
SYSTEM CHECK-RESET
pad will erase two
codes immediately—
PF
and
CI.
The
dE
and
FF
codes can
only be erased by touching the
SYSTEM CHECK-RESET
pad after the condition that caused the code to flash has
been corrected.
The word
NORMAL
is lighted except when a failure has
been detected.
The SYSTEM CHECK-RESET pad has two functions:
You can touch the
SYSTEM CHECK-RESET
pad and
get a review of the electronic diagnostic codes in
order of their priority.
You can touch the
SYSTEM CHECK-RESET
pad to
erase two flashing codes immediately and two codes
after the condition that caused them to flash has
been corrected.
2
1
To Next Page
Loading...
Need help?
General
