Installation Instructions
TURN ON THE WATER SUPPLY
(Icemaker models)
Turn the water on at the
shutoff valve (house water
supply) and check for any
leaks.
7
PLUG IN THE REFRIGERATOR
On models with an icemaker,
before plugging in the
refrigerator, make sure the
icemaker power switch is set to
the 0 (off) position.
See the grounding information
attached to the power cord.
PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
8
9
LEVEL THE REFRIGERATOR
Adjustable legs at the front corners of the
refrigerator should be set so the refrigerator is
firmly positioned on the floor, and the front is
raised just enough that the door closes easily
when opened about halfway.
To adjust the leveling legs, turn the
legs clockwise to raise the refrigerator,
counterclockwise to lower it.
10
31
LEVEL THE REFRIGERATOR DOORS
(on some models)
Remember a level refrigerator is necessary for
getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
If the doors remain uneven, turn the adjustable pin
to raise the lowest door using a 1/4” allen wrench to
turn the pin.
11
When
the left
door is
lower than
the right
door.
When
the left
door is
higher
than
the right
door.
Adjustment point
To Next Page
Loading...
Need help?
General
