Your remote is designed to control multiple audio/video
devices. To use, you will need to program the remote for
your devices. There are two different methods you can
use to program the remote, Direct Code Entry or Auto
Code Search.
• The Direct Code Entry method is the recommended
method as it is the simplest and quickest method in
most cases.
• The Auto Code Search method searches through
all the codes in the remote to find a code for
your device.
Note: this remote comes preprogrammed for Samsung TVs. Press
TV for Samsung TVs.
Direct Code Entry (Recommended)
1. Locate the Code List included with
your remote. Find the section for the
type of device you wish to control,
(for example TV, cbl, dvd, aux). Locate
the brand of your device and circle all
the remote codes for the brand.
2. Press and hold down the SETUP
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
Note: The red light will either be a small light at the
top of the remote or the power on/off button.
3. Press and release the device button
on the remote for the type of device
you wish to control, (for example TV,
cbl, dvd, aux). The red light will blink
once and remain on.
Note: Any of the device buttons on the remote can
be programmed to control any of your devices. For
example, you can use the CBL device button on
the remote to control a Satellite Receiver, Digital
Converter Box, Streaming Media Player or any
device category in the Code List.
To Next Page
Loading...
Need help?
General
