GE 535 Series - User Manual

Questions and Answers

C
cpittmanSep 14, 2025
Why does my GE 535 Dishwasher have long cycle times?
- A
  Anna OrtizSep 14, 2025
  Long cycle times on your GE dishwasher can be attributed to: * Alternating spray arms: The dishwasher washes by alternating between the mid and lower spray arms, which can extend the cycle. Longer cycles are normal. For best wash and dry performance, let the cycle complete. * Soil level: On some models, the turbidity sensor detects the amount of soil on the dishes. Heavily soiled dish loads will add more time to the cycle, which is normal. For best wash and dry performance, allow the cycle to complete.
A
anna98Sep 13, 2025
Why are there suds in the tub of my GE 535 Dishwasher?
- D
  David MarshallSep 13, 2025
  Suds in the tub of your GE dishwasher can be caused by: * Using the wrong detergent: Use only high-quality automatic dishwasher detergents to avoid sudsing. Cascade® Platinum™ ActionPacs™ or Finish® Quantum® Automatic Dishwashing Detergent have been approved for use in all GE Appliances dishwashers. To remove suds from the tub, open the dishwasher and let suds dissipate. Pump out water by pressing Start and close the door. Wait 30 seconds. Open the door, press and hold Start for 3 seconds, and close the door. Repeat if necessary. * Spilled rinse agent: Always wipe up rinse agent spills immediately.
R
Robert RodriguezSep 12, 2025
What does it mean when my GE Dishwasher start status indicator light is flashing?
- A
  Ashley WilliamsSep 12, 2025
  If the start status indicator light is flashing, it means the door was opened or the cycle was interrupted. Press the Start pad once and close the door within 4 seconds to start the dishwasher. Press and hold, for 3 seconds, the Start pad a second time when the dishwasher is running only if you wish to cancel the cycle. If problem persists, call for service.
R
Robert WashingtonSep 12, 2025
How to stop cloudiness on glassware in my GE Dishwasher?
- W
  William BrooksSep 12, 2025
  Cloudiness on glassware can occur if you have a combination of soft water and are using too much detergent; this is called etching and is permanent, so use less detergent if you have soft water. Also, if the water temperature entering the dishwasher exceeds 150°F (66°C), lower the water heater temperature.
M
Misty JacksonAug 25, 2025
What to do if water won’t pump out of the tub of my GE 535 Dishwasher?
- C
  Christine FrancisAug 26, 2025
  If water won’t pump out of the tub of your GE dishwasher, it's likely due to a clogged drain. If you have an air gap, clean it. If the dishwasher drains into a disposer, run disposer clear. Check to see if your kitchen sink is draining well. If not, you may need a plumber.
J
Joe KellerSep 9, 2025
How to fix spots and filming on glasses and flatware in GE Dishwasher?
- T
  Thomas McdowellSep 9, 2025
  Spots and filming on glasses and flatware can be due to several factors. If you have extremely hard water, use high quality rinse agents such as Cascade® Platinum™ Power Dry™ Rinse Aid or Finish® Jet-Dry® Rinse Aid. Ensure the inlet water temperature is at least 120°F (49°C). Avoid overloading or improperly loading the dishwasher. Make sure your powder detergent is fresh, and refill the rinse agent dispenser with high quality rinse agents if it's empty. Also, ensure you are using the proper amount of highly rated detergent.
T
Tina JohnsSep 8, 2025
How to remove black or gray marks on dishes from my GE 535?
- M
  Matthew WangSep 8, 2025
  Black or gray marks on dishes are usually caused by aluminum utensils rubbing against the dishes. Remove the marks with a mild, abrasive cleaner.
N
Natasha MontoyaSep 7, 2025
What to do if there is cloudiness on glassware in my GE Dishwasher?
- J
  Jeremiah RossSep 7, 2025
  Cloudiness on glassware can be due to a few reasons: * A combination of soft water and too much detergent can cause etching, which is permanent. To prevent this, use less detergent if you have soft water and wash glassware in the shortest cycle that will get it clean. * Low-performing phosphate-free detergent. See A white film on glassware, dishware, and the interior in this TROUBLESHOOTING section. * Water temperature entering the dishwasher exceeding 150°F (66°C). Lower the water heater temperature.
A
Andrew DorseySep 4, 2025
What to do if water won’t pump out of the tub in my GE 535 Dishwasher?
- J
  Jeremy VasquezSep 4, 2025
  If water won’t pump out of the tub, the drain may be clogged. If you have an air gap, clean it.
G
gabrielamercerSep 3, 2025
What to do if my GE Dishwasher control panel responded to inputs but dishwasher never filled with water?
- K
  Kelly GoldenSep 3, 2025
  If the control panel responds but the dishwasher doesn't fill with water, make sure the door is firmly closed and that the water valve (usually located under the sink) is turned on.

GE 535 Series Specifications

General

Type	Built-In
Control Type	Electronic
Number of Wash Cycles	6
Energy Star Certified	Yes
Soil Sensor	Yes
Stainless Steel Tub	Yes
Heated Dry	Yes
Delay Start	Yes
Features	Hard Food Disposer, Sanitize Option