CHAPTER 4: SETPOINTS CONTROL
845 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL 4–299
SET GROUP 2 (3,4,5,6) ACTIVE
Range: Off, Any FlexLogic operand
Default: Off
The setpoint selects the FlexLogic operand that initiates change of the Active Setpoint
Group.
GROUP CHANGE INHIBIT 1 (UP TO 16)
Range: Off, Any FlexLogic operand
Default: Off
The setpoint selects the FlexLogic operand that inhibits change of the active setpoint
group.
EVENTS
Range: Disabled, Enabled
Default: Enabled
To Next Page
Loading...
