11
Operating A VCROperating A VCR (con’t)
4. Press STOP when you are
finished.
5. Press REW to rewind the
tape.
6. Press PAUSE to pause the
tape.
7. Press RECORD twice to begin
recording.
1. Manually turn on your TV,
VCR or Cable Box.
2. Press the Device button (TV,
VCR/DVD, or CBL/AUX) for five
(5) seconds. The Indicator
Light will go on. Then
release the device button.
3. Press and release POWER
until the device turns off
(you may have to repeat up to
200 times at a rate of
once per second).
4. Press the STOP button.
5 . The Indicator Light will go off.
Programming Using Code Search
If your TV, VCR or Cable Box does not respond to your
remote after you have tried all the codes for your brand,
try searching for your code.
Program a device button using Code Search.
94948 Revised Size 1/21/02 2/25/02 4:28 PM Page 12
To Next Page
Loading...
