80 8181
Connecting the camera and printer.
1. Make sure both the camera and printer are turned
on.
2. Connect one end of the supplied USB cable to the
USB port on your camera.
3. Connect the other end of the cable to the USB port
on the printer.
If the camera is not connected to a PictBridge
compatible printer, the following error message appears
on the LCD screen.
The above error message would also appear if the
USB mode were set incorrectly, in which case you
should disconnect the USB cable, check the USB
mode settings, ensure that the Printer is turned
on, and then try connecting the USB cable again.
To Next Page
Loading...
