About the controls on the air conditioner-Heat/Coo! Modds
Appearance may vary.
ON
® OFF
TIMER
't
® COOL
Q FAN
® HEAT
TEMP
Q HiGH
• Low
,
Air Conditioner Controls
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
ON/OFF
__J
Remote Control
Controls
O ONIOFF
Turns air conditioner on and off.
O isplag
Displagsthe temperature setting. Displags
hourswhen setting the timer.
@
O
0
MODE
On the air conditioner controls, useto set
COOL,HEATor FANmode. Indicator lights
on the air conditioner controls will show the
mode selected.
TEMP Increase +/Decrease - Pads
Useto set temperature when in COOL
or HEATmode.
FAN Speeds
Useto set the fan speed at LOW or HIGH.
Indicator lights will show the speedselected.
O
0
TIMER
ON--When the air conditioner isoff, it can
be setto automaticallg turn on in half an
hour to 24 hours at its previous setting.
Eachtouch will set the time in half hours
up to 10and then in hours up to 24.
Tocancel the On Timer,pressthe ON pad
until the displagtime disappears.
OFF--When the air conditioner ison, it can
be set to automaticallg turn off in half an
hour to 24 hours. Eachtouch will set the
time in half hours up to 10 and then in hours
up to 24.
Tocancel the Off Timer,pressthe OFFpad
until the displagtime disappears.
Remote Control Signal Receiver
NOTE:When the air conditioner isturned on,
it will automaticallg start in the setting last used.
Remote Control
Toensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
E Theremote control signal has a range
of up to 21feet.
E Makesure nothing isbetween the air
conditioner and the remote control that could
block the signal.
E Makesure batteries are fresh and installed
correctly-see the Careand Cleaning section.
6
To Next Page
Loading...
