IMPORTANTSAFETYINFORMATION.
READALLINSTRUCTIONSBEFOREUSING.
A WARNING'!
For your safe_ the information in this manual must be followed to minimize the risk of fire, electric
shock or personal injury.
SAFETYPRECAUTIONS
iiiiiiiiiiii_iii
iiiiiiiiiiii_iii
iiiiiiiiiiii_iii
Use this appliance only %r its intended
puq)ose as described in this Owner's
Manual.
This air conditioner must be properly
installed ira accordance with the
Installation Instructions 1)efore it is used,
Nexer unplug yonr air conditioner 1)y
pulling on fl_e power cord. Always gaiI)
plug fimgv and pull straight out flom the
receptacle.
Repair or replace immediately all elecwic
service cords that haxe become frwed or
otherwise damaged. Do not use a cord
that shows cracks or abrasion damage
along its length or at either the plug or
connector end.
Turn the mode control OFFand unplug
your air conditioner 1)efore making any
repairs or cleaning.
NOTE:Westronglyrecommendthat anyservicing
beperformedbya qualified individual
For your safety...do not store or use
combustible mamrials, g_soline or other
flammable vapot_ or liquids ira the vicinity
of this or any other appliance.
All air conditioners contain refligerants,
which under federal law must be remoxed
prior to product disposal. If you are g>tting
rid of an old product wifl] refl-igerants,
check with the company handling disposal
about what to do.
HOWTOCONNECTELECTRICITY
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
For personal safety, this appliance must be
properly grounded.
The power cord of this appliance is equipped
with a 3-prong (grounding) ping which
mares with a standard 3q)rong (grounding)
wall outlet m minimize the possibility of
electric shock hazard flom this appliance.
Haxe the wall outlet and circuit checked
by a qualified electrician to make sure the
outlet is properly grounded.
Where a 2-prong wall ontlet is encounmred,
it is your personal responsibility and
obligauon m lame it replaced with a properly
grounded 3-prong wall outlet.
The air conditioner should always be plugged
into its own individual electrical outlet which
has a xoltage rating that matches the rating
plate.
This provides the best performance and also
prevents oxerloading house wiring circuits
which could cause a fire hazard flom
oxerheated wires.
See the Installation Instructions, Electrical
Requirements section for specific electrical
connection requirements.
2
To Next Page
Loading...
