GE Appliances 25

Installation
Instructions
Refrigerator
Models 21 and 25
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT- Savetheseinstructionsforlocal
inspector's use.
• IMPORTANT-Obse_eallgoverning codesand
ordinances.
• Note to Installer - Besure to leave these instructions with
the Consumer.
• Note to Consumer - Keepthese instructions for future
reference.
• Skill level- Installation of this appliance requiresbasic
mechanical skills.
• Completion time - RefrigeratorInstallation
20 minutes
Water Line Installation
S0 minutes
Anti-Tip BracketInstallation
20 minutes
• Properinstallation is the responsibilityof the installer.
• Productfailure due to improper installation is not covered
under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• Toremove the refrigerator door,seeStep1 in the
Reversingthe Door Swing section.
• Toremove the freezer drawer,see the Removing the
FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
(ON SOME MODELS)
If the refrigerator has an icemaker,itwill have
to be connectedto a cold water line.A GEwater supply kit
(containing tubing, shut-off valve,fittings and instructions)is
availableat extra cost from
your dealer,byvisiting our Website at GEAppliances.com(in
Canadaat _v.GEAppliances.ca)or from Partsand
Accessories,800.626.2002(InCanada 1.800.661.161@.
MATERIALS YOU MAY NEED (not included)
Lag Bolts
Drill Bit Appropriate for Anchors
Anchor Sleeves
For Anti-Tip Bracket Mounted on CONCRETEFloors Only
TOOLS YOU MAY NEED
Adjustable Wrench
3/8" and 5/16" Socket
Ratchet/Driver
1/4" Outer Diameter
Compression Nut
and Ferrule (sleeve)
(icemaker models only)
Phillips-Head Screwdriver
3/32% 1/8" and 1/4" Allen
wrenches
1/8" Drill Bit and
Electric or Hand Drill
Tape measure
Pencil
1/4" Nut Driver
Wire Cutters
Level
18