GE ASM24 - Page 7

GEAppliances.com
Additional controls and important information.
Energy Saver (on some models)
Tile energa, saver switch controls tile thn.
ON--The tim and compressor cycle on and off
together: This results in wider \m_iafions ot room
temperature and humidity. Nommllv used when
tile room is unoccupied.
OFF--The tim runs all tile time, while tile
COli/pi'essoi" cycles on and oJ_.
This switch nlust be set at OFFin order to use
the tim settings (on the mode control).
ON • OFF
ENERGY SAVER
Vent Control (on some models)
Tile vent control is located on tile inside ot tile air
lou\'eI_ in tile lower right corner.
When set at CLOSE,only tile air inside tile room
will be circulated and conditioned. _._]/en set at
OPEN, some inside air is exhausted outside.
(/
(z
g,
v
Toopen the vent, push fl?elever to fl?eright.
Toclose it, push it to the left.
Air Direction--Side-to-Side
On some models, tile side-to-side air direction is
a(!iusted b) tile l()uver leveI_ (1i"by, _grasl)ing_ and
m()xiw* tile inner xertical l()uxei_.
AUTO CIRCULAIRE (on some models)
For fixed side-t(_side air direction, set tile
Auto Circulaire switch to ONuntil tile desired air
direction is obtained; then move it to O/f.
For continuous side-to-side air circulation, set tile
Auto Circulaire switch to ON and leave it there.
ON • OFF
CIRCULAIRE
Air Direction--Up and Down (onsomemodels)
Fingertip pressure on tile horizontal louxei_ a(!iusts
tile air direction up (1i" down.
OR
7