Beforeyoucall forservice.., ge.oo
_ roubleshooting tips
Save time and money! Review flTecharts on the following
ages first and you may not need to call for service.
Problem Possible Causes What ToDo
Zoneline does The refit is • Make sure tilt' Z()m'linc plug is pushed (omph'tel)
notstart tmplugged, into th(, oull_ t.
The power cord is not **Remove the room calfinet and make sur( that the
firnfly attached, vcllow (onne( tor on the end of the Dower tord is
ti rlnly engaged.
The fuse is blown/circtfit • Che(k the house filseicir(uit breaker 1)ox and r_ pla(_
breaker is tripped, the ills( or res(t lhe br(aker.
The unit is waith ,lg for • This is normal. The Zonelinc will start again after
the compressor overload it rt,sels.
protector to reset.
Power f,-fihuce.
• If po_ (r tililure occurs, set the mode control to STOP.
Wh(n power is restored, set the mode (ontrol to the
desired setting.
• Ther( is a l)rotectiv( time (lel m (u l) to 3 min!/ms) to
l)revent tripping ot the compressor ov( rload. For this
reason, th( tlllit may 11o1start normal heating or cooling
for 3 minutes afler it is turned back on.
The current interrupter • Pres_ tile RESETbutton located Oll the power cord phlg
device is lripped, or lhe 1)ox near the [)hlg.
• If lhe RESETbutton will not stay engaged, dis(:ontimle !lSe
of the Zoneline and contact a qualitied sel-vi(e technician.
Zoneline does not cool Indoor airflow • Make sure there arc no curtains, blinds or furniture
or heat as it should is restricted. /)locking the h-()nt of"the Zondine.
Outdoor airflow is • Make sure the rear glille is not rcstricte(1. This can
restricted or recirculated, cruise tim unit to cvcle, offdue m the compressor
ox erloa(I [)rotectol_
• Outdoor grille nlust have a minimum of 65% tree area.
Non-GE grilles may be 1oo restlictive tbr proper
[)erfbrmanc(. (:onsuh }our salesperson fbr assismnc(.
The temp control may • "Iinn the control to a lower or higher setting.
not be set properly. NOTE:?7_etemperatureIimi>,rmayt)_,limiting t/?etemperaturerange
The air filter is dir_; • Clean the fiher at l(ast (V(T) 30 (lays.
See th( Operating Instructions section.
The room mayhave " When tim Zoneline is lil_,t turned on you need to
been hot or cold. allow time fbr the room to cool down or wmm Ul).
Outdoor air is • Set th( vent control to the ch_ed position.
entering the room.
Burning odorat the start Dust is on the surface • rI'his can (mist a %urning" odor at lla( I)eginning ot
of heating operation of the heating element, the heating operation. This odor should qui( kl 3 fh(le.
2!
To Next Page
Loading...
Need help?
General
