Beforeyoucall forservice...
Problem Possible Causes What To Do
The air is not always The heat pump is not * This is normal. The heat pUlnl) will lm_lm c warm air
cool or hot doring producing hot air. bm noI ;as hot ;asair l)rC_lu(ed _qlen the high(r_:ost
operation (le(tric heat is us(d.
The fan switches may be *' This t mlscs the thn to blo_ rooln tcnlpcraturu air
set at continuous fan. even when tile compressor or he_lter cycles off.
The <ontimlous air movement provides hetter
overall temperature control in tile cool mode.
• There is one switch tk)r cooling and one switch
tk)l h_ ating.
The air does not feel The heat pump alone • Ls( the Ele( tric If(at Option. This turns oft tile
warm enough during produces air that feels he,it pump and warms with electri( heat only.
heating operation cooler than desired. NOTE: Use of this option wifl result in increased energy
CORSUITI_t/oR
The unit is not The fan dip switch nlay • See tile Auxiliary Controls s_ ction.
blowing out air be set to CYCLE.
The electric heating The power cord is not • Renlove Ill( /'()()Ill I abint't and mnke sure their the
feature does not work firmly attached, yellow conne(tor on tile end of the power cord is
fmnly ( ngag_ d.
Temperature display The compressor may
flashes have failed.
• Set the operation control to STOP and then restart
tile unit. If th( flashing light reapp(ars within
3() minutes, tall t;,n- setwi( e.
22
To Next Page
Loading...
