2-208 UR FAMILY – COMMUNICATIONS GUIDE
MEMORY MAP CHAPTER 2: MODBUS COMMUNICATION
2
F259
ENUMERATION: BRICK RTD TYPE
0 = 100 Ohm Nickel, 1 = 120 Ohm Nickel, 2 = 100 Ohm Platinum
F260
ENUMERATION: DATA LOGGER MODE
0 = Continuous, 1 = Trigger
F261
ENUMERATION: BANK REDUNDANCY TYPE
0 = None, 1 = Dependability Biased, 2 = Security Biased
F262
ENUMERATION: BRICK STATUS
0 = Disabled, 1 = OK, 2 = Communications Trouble, 3 = Equipment
Mismatch, 4 = Brick Trouble
F270
ENUMERATION: FAULT REPORT VT SUBSTITUTION
F280
ENUMERATION: BREAKER/SWITCH NV LATCH PACKED
STATES BIT POSITIONS
F281
ENUMERATION: BREAKER/SWITCH PACKED STATES BIT POSI-
TIONS
F282
ENUMERATION: BREAKER/SWITCH COMMAND
F300
UR_UINT32: FLEXLOGIC BASE TYPE (15-bit type)
The FlexLogic BASE type is 14 bits and is combined with a 17-bit
descriptor and 1 bit for the protection element to form a 32-bit
value. The combined bits are of the form:
PTTTTTTTTTTTTTTDDDDDDDDDDDDDDDDD, where P bit if set
indicates that the FlexLogic type is associated with a protection
element state and D represents bits for the type in F124 format. If
P bit is not set, then the T represents bits for the type and D repre-
sents range.
The values in square brackets indicate the base type with P prefix
[PTTTTTTTTTTTTTT] and the values in round brackets indicate the
descriptor range. The left-most D bit indicates whether the type is
an ON or OFF type. There can be a total 65535 BASE type ele-
ments, 131071 protection element IDs, and 16383 element states.
There can be a total of 65535 descriptors of each type.
[0] Off (0) – This is boolean FALSE value
[1] On (1) – This is boolean TRUE value
[2] CONTACT INPUTS (1 to 120)
[3] CONTACT INPUTS OFF (1 to 120)
[4] VIRTUAL INPUTS (1 to 32)
[6] VIRTUAL OUTPUTS (1 to 64)
Value Description
0None
1I0
2V0
Value Description
0 Tagged Bit
1 Subd Closed Bit
2 Subd Open Bit
3 Bypassed Bit
4 Blk Rcls Bit
Value Description
0Closed Bit
1Open Bit
2Discrep Bit
3Ph A Interm Bit
4 Ph B Interm Bit
5Ph C Interm Bit
6 Bad Status Bit
7 OOS Bit
8 Tagged Bit
9Subd Clsd Bit
10 Subd Open Bit
11 Bypassed Bit
12 Blk Rcls Bit
13 Ar Armed Bit
14 Racked In Bit
15 Trouble Bit
Value Description
0Cancel
1Open
2Close
3Tag
4Untag
5 Substitute Closed
6 Substitute Open
7 Remove Substitution
8 Bypass
9 Remove Bypass
10 Block Autoreclose
11 Unblock Autoreclose
Value Description
To Next Page
Loading...
