GE b30 - Page 320

3-82 UR FAMILY – COMMUNICATIONS GUIDE
MODEL IMPLEMENTATION CONFORMANCE STATEMENT (MICS) CHAPTER 3: IEC 61850 COMMUNICATION
3
3.5.2.52 Permissive over-reaching transfer trip (POTT3)
This element is instantiated in the following products: F60.
Table 3-85: POTT3 data objects
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef7 ORG DIR FWD2 setting. R
setSrcRef ObjectReference SP DIR FWD 2 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef8 ORG DIR FWD3 setting. R
setSrcRef ObjectReference SP DIR FWD3 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef1 ORG POTT1 RX1 setting. R
setSrcRef ObjectReference SP POTT1 RX1 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef2 ORG Instantiated only on products with single
pole tripping.
R
setSrcRef ObjectReference SP POTT1 RX2 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef3 ORG Instantiated only on products with single
pole tripping.
R
setSrcRef ObjectReference SP POTT1 RX3 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef4 ORG Instantiated only on products with single
pole tripping.
R
setSrcRef ObjectReference SP POTT1 RX4 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
LNName: POTT3_PSCH1 LDevice inst: Prot UR element: Permissive Over-reaching Transfer Trip 3 element
data obj. data attribute Type FC UR Name Description R/W/C
Op ACT POTT3 OP operand R
general BOOLEAN ST POTT3 OP R
TxPrm ACT POTT3 TX operand R
general BOOLEAN ST POTT3 TX R
BlkRef1 ORG POTT3 SCHEME BLOCK setting. R
setSrcRef ObjectReference SP POTT3 SCHEME BLOCK reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef01 ORG POTT3 DIR FWD1 setting. R
setSrcRef ObjectReference SP POTT3 DIR FWD1 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef02 ORG POTT3 DIR FWD2 setting. R
setSrcRef ObjectReference SP POTT3 DIR FWD 2 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef03 ORG POTT3 DIR FWD3 setting. R
setSrcRef ObjectReference SP POTT3 DIR FWD3 reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef21 ORG POTT3 RX setting. R
setSrcRef ObjectReference SP POTT3 RX reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
InRef22 ORG LINE END OPEN setting. R
setSrcRef ObjectReference SP LINE END OPEN reference to the data attribute to input R/C
setSrcCB ObjectReference SP source GoCB of input if via GOOSE R/C
LNName: POTT1_PSCH1 LDevice inst: Prot UR element: Permissive Over-reaching Transfer Trip 1 element
data obj. data attribute Type FC UR Name Description R/W/C