About crisper removal.
Not all features are on all models.
Crisper Removal
Crispers can easily be removed by pulling
the drawer straight out and lifting the
drawer up and over the stop location.
If the door prevents you from taking out
the drawers, first try to remove the door
bins. If this does not offer enough
clearance, the refrigerator will need to
be rolled forward until the door opens
enough to slide the drawers out. In some
cases, when you roll the refrigerator out,
you will need to move the refrigerator
to the left or right as you roll it out.
11
About the crispers and pans.
Not all features are on all models.
ge.com
Adjustable Humidity Crispers
Slide the control all the way to the
HI setting to provide high humidity
recommended for most vegetables.
Slide the control all the way to the
LO setting to provide lower humidity
levels recommended for most fruits.
Consumer Support
Troubleshooting TipsOperating Instructions
Safety Instructions
Installation Instructions
Door Alignment
If doors are uneven, adjust the refrigerator
door.
Using a 7/16″ wrench, turn the door
adjusting screw to the right to raise the
door, to the left to lower it.
(A nylon plug, imbedded in the
threads of the pin, prevents the pin
from turning unless a wrench is used.)
After one or two turns of the wrench,
open and close the refrigerator door
and check the alignment at the top
of the doors.
7/16″ Wrench
Fruit and Vegetable Crispers
Excess water that may accumulate in the
bottom of the drawers should be wiped dry.
To Next Page
Loading...
Need help?
General
