M1807013 Rev. F 01 15 Page 2 of 6
This document contains confidential information or proprietary information of General Electric Company or its af-
filiates. Neither the document nor the information therein is to be reproduced, distributed, used, or disclosed, either
in whole or in part, except as specifically authorized in writing by a General Electric Company and must be returned
upon request.
Installation Instructions, For Field Use
For future reference add to your Technical Reference Manual
Datex-Ohmeda, Inc.
3030 Ohmeda Drive
PO Box 7550
Madison, WI 53707-7550, USA
3. Unpack the transportation package from the pendant mount anesthesia machine.
4. If present, remove any extra load attached to the Carestation 650c top shelf and tabletop; for example, monitors,
accessories, etc.
5. Loosen the screws of the two tilt blocks (located on the lower rear panel of anesthesia machine). Slide the tilt blocks
to the far left and far right positions.
6. Turn the tilt adjustment screw (C) counterclockwise till the screw bolt end recedes into the hole.
To Next Page
Loading...
