GE CDT725SSFSS Dimensions And Installation Information

Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
Cafe
™
Series,
Profile
™
Series or GE
®
appliance questions, visit
our website at geappliances.com or call GE
Answer Center
®
service, 800.626.2000.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
24"
Typical
33-3/8" MIN.
adj to
34-5/8" MAX.
23-3/4"
29-7/8"
27-1/2"
4"(toekick)
Listed by
Underwriters
Laboratories
ERUSOLCNE REHSAWHSID ERAPERP
• The rough cabinet opening must be at least 24" deep, 24"
wide and approximately 34-1/2" high from floor to underside
of the countertop.
24"
Min.
This Wall Area
must be Free
of Pipes or
wires
Plumbing and Electric Service
Must Enter Inside This Area
4"
24"
Min.
6"
Cabinets
Square
and
Plumb
+
34-1/2" 1/4"
Underside of
Countertop
to Floor
Figure A
33-1/2” to 34-3/4”
Underside of
Countertop
to Floor
Electrical Rating
Voltage AC.......................................................... 120
Hertz..................................................................... 60
Total connected load amperage............ 7.1
Calrod
®
heater watts max............. 415/800
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service
with a separate ground wire. This appliance must
be grounded for safe operation.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
Specification Revised 8/13
350299
CDT725SSF
GE Cafe
™
Series Stainless Steel Interior Dishwasher with Hidden Controls

GE CDT725SSFSS Specifications

General

Brand	GE
Model	CDT725SSFSS
Category	Dishwasher
Language	English