GE CT ProSpeed Series

GE MEDICAL SYSTEMS CT PROSPEED SERIES INSTALLATION
2124011
v
REV 13
NOTE (continued)
Torque Notation Changed to SI Unit
The unit expressed on the torque wrench supplied by GEYMS has been changed from “kgf Scm” to “NS m” (SI
Unit).
Therefore, for the torque values (kgf S cm) of this manual, convert “N S m” using the following conversion formula
and table.
Conversion Formula:
xx (NSm) = xxxx (kgfS cm) x 0.098
Conversion T able:
1 kgf S cm = 0.098 N Sm
Coversion: kgfS cm –> N Sm
kgfScm 0 1 2 3 4 5 6 7 8 9
NSm
0 0 0.0981 0.1961 0.2942 0.3923 0.4903 0.5884 0.6865 0.7845 0.8826
10 0.9807 1.0787 1.1768 1.2748 1.3729 1.4710 1.5690 1.6671 1.7652 1.8632
20 1.9613 2.0594 2.1574 2.2555 2.3536 2.4516 2.5497 2.6478 2.7458 2.8439
30 2.9420 3.0400 3.1381 3.2361 3.3342 3.4323 3.5303 3.6284 3.7265 3.8245
40 3.9226 4.0207 4.1187 4.2168 4.3149 4.4129 4.5110 4.6091 4.7071 4.8052
50 4.9033 5.0013 5.0994 5.1974 5.2955 5.3936 5.4916 5.5897 5.6878 5.7858
60 5.8840 5.9820 6.0800 6.1781 6.2762 6.3742 6.4723 6.5704 6.6684 6.7665
70 6.8646 6.9626 7.0607 7.1587 7.2568 7.3549 7.4529 7.5510 7.6491 7.7474
80 7.8452 7.9433 8.0413 8.1394 8.2375 8.3355 8.4336 8.5317 8.6297 8.7278
90 8.8260 8.9239 9.0220 9.1200 9.2181 9.3162 9.4142 9.5123 9.6104 9.7084
100 9.8065