MAINTENANCE/CLEANING
STORAGE
5
6
• To maintain high efciency of the lens, occasional
cleaning of the outer lens surface may be needed,
with frequency dependant on local conditions.
• Use a mild, non-abrasive soap or detergent, of neutral
pH (pH approximately 6 to 8), containing no chlorinated
or aromatic hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
One Piece Refractor Replacement
To remove a textured refractor on this luminaire:
• Loosen the canopy captive screw or latch and tilt
back the canopy.
• Remove the refractor assembly unit.
• To replace refractor, reverse this procedure.
PHOTOELECTRIC CONTROL
4
•
Orient the photoelectric (PE) receptacle so that the
word “North” is directed toward true north.
• Lower the PE receptacle to seat in position. Install PE
control.
• Secure cupola over the photoelectric control with
the window properly oriented in regard to the sensor.
Because of the shielding of the cupola window by the
cupola top it may be necessary to adjust for an earlier
turn-on time of the photoelectric control.
• Packaged units should NOT be stored unprotected
outdoors in corrugated (cardboard) boxes.
• Store packaged units in a covered dry area not
exceeding -40°C (-40°F) to 50°C (122°F) such as a
roofed area or covered with a secured tarp to keep
water off the corrugated (cardboard) packaging.
Risk of electrical shock. Make certain power is off before
attempting any maintenance of the product.
WARNING
To Next Page
Loading...