GE DCCH480EK - Door Swing Reversal Steps; REMOVE THE DOOR ASSEMBLY; DISASSEMBLE THE DOOR ASSEMBLY

REMOVE THE DOOR ASSEMBLY
Remove hinge bracket anchoring screws.
1
DISASSEMBLE THE DOOR ASSEMBLY
Remove 16 door screws and male end of latch
from the inner side of the door.
2
Remove the inner face.
Installation Instructions
20
BEFORE YOU START
Unplug the dryer from its electrical outlet.
REVERSING THE DOOR SWING (if desired)
Slide door and hinge assembly upward; then
remove the assembly from the dryer front panel.
Lift and rotate the window assembly 180º and
replace. Also rotate the inner face 180° and
replace.