STEP-BY-STEP INSTRUCTIONS (cont.)
Reinstall Nuts and Hinge Cover
14. Place the door on its edge. Assemble the 2 machine screws (#8), washers
and nuts. Tighten using a wrench and screwdriver.
15. Place the hinge cover in position. Align the hinge cover holes with the holes
in the door.
16. Secure the hinge cover with the 2 tapping screws (#8).
Reassemble Door Assembly
IMPORTANT: Make sure there is no dirt or any other foreign material in between
the window panes.
17. Place the plastic cover onto the inner door and lock in place with the 4 tabs.
18. Place the outer door onto the inner door.
Outer
Door
Inner
Door
Top of Door
14
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
Reversing the door swing.
To Next Page
Loading...
