ge.com
"F- and a number
or letter" flash
in the display
Possible Causes
You have a function
error code,
What ToDo
• Disconnect all power to the range tbr at least 30
seconds and then recolmect power. If the flmction
error code repeats, call tor service.
• On seltXcleaning lnodels, if a flmction error code
appears during the selt:cleaning cycle, check the oven
door latch. The latch inav have been inoved, it only
slightly, ti'Oln the locked position. Make sure the latch
is inoved to the fight as tar as it will go. Touch the
Clear/Off pad. _Mlow the oxen to cool tor one houi _.
Put the oven back into operation.
Display flashes "bAd" The installed cmmection • (;ontact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone is miswired.
Displaygoesblank A fuse in your home may be • Replace the fl/se ()r reset the circuit breakel:
blown or the circuit
breaker tripped.
The clock is turned off from • See the Using the clock and timer section.
showing ha the display.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads must be touched
display to show "SF" not pressed properly, at the s;nne time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock./f tile oven was in use, you must reset
clock flashes it by t(mching the Clear/Off pad, setting the clock
and resetting any cooking flmction.
"Burning" or "oily" This is normal in a new • To speed the process, set a sell_clean cycle for a
odor emitting from oven mad will disappear minimum of .'4hours. See the Using the self-cleaning
the vent in time, oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
3/
To Next Page
Loading...
Need help?
General
