To Next Page
L
Lisa FloresSep 13, 2025
Why is my GE Ranges making fan noise?
- VvhuynhSep 13, 2025
The cooling fan in your GE Ranges may automatically turn on and off to cool internal parts, which is normal. The cooling fan will cycle on and off as needed.
Why is my GE Ranges making fan noise?
The cooling fan in your GE Ranges may automatically turn on and off to cool internal parts, which is normal. The cooling fan will cycle on and off as needed.
What to do if my GE EGR2000 oven will not self-clean?
If your GE Ranges oven won't self-clean, first ensure the oven isn't too hot; allow it to cool to room temperature before trying again. Also, make sure the oven controls are properly set by consulting the 'Using the self-cleaning oven' section. Finally, if your model has a door latch, ensure the oven door is fully locked by moving the door latch handle all the way to the right.
What to do if my GE Ranges oven door will not open after a clean cycle?
If the oven door on your GE Ranges won't open after a clean cycle, the oven may still be too hot. Allow the oven to cool below the locking temperature.
Why is there fan noise coming from my GE EGR2000 Ranges?
A cooling fan may automatically turn on and off in your GE Ranges to cool internal parts. This is normal.
How to fix GE EGR2000 Ranges top burners that do not light or do not burn evenly?
If the top burners on your GE Ranges don't light or burn evenly, first, ensure the range is fully plugged into a properly grounded electrical outlet. If that's not the issue, the burner holes or slits might be clogged; remove the burners or burner heads and caps to clean them carefully with a sewing needle or twist-tie, being careful not to enlarge the holes. For sealed burner models, inspect and clean the electrode area. Finally, ensure all burner parts are correctly assembled.
Why does the display go blank on my GE EGR2000?
If the display on your GE Ranges goes blank, a fuse in your home may be blown, or the circuit breaker tripped. Replace the fuse or reset the circuit breaker. Also, the clock may be turned off, so it does not show in the display. See the Using the clock and timer section.
Why there is a burning or oily odor emitting from the vent of my new GE Ranges?
If you notice a burning or oily odor coming from the vent of your new GE Ranges, this is normal and should disappear over time. To speed up the process, you can set a self-clean cycle for a minimum of 3 hours.
Why are the burner flames very large or yellow on my GE Ranges?
If the burner flames on your GE Ranges are very large or yellow, it indicates an improper air-to-gas ratio. If your range is connected to LP gas, contact the person who installed your range or made the conversion.
How to get the display to show “SF” on GE Ranges?
If you're unable to get the display to show “SF” on your GE Ranges, it means the oven control pads were not touched properly. Ensure that you touch the Bake and Broil Hi/Lo pads simultaneously and hold them for 3 seconds.
Why are my GE EGR2000 Ranges burner flames very large or yellow?
If the burner flames on your GE Ranges are very large or yellow, it indicates an improper air-to-gas ratio. If your range is connected to LP gas, contact the person who installed your range or made the conversion.
General
