GE EGR2000 User Manual

GEAppliances.com
Excessivesmoking
Possible Causes
Excessivesoil.
What To Do
On models with touch pads, touch the Clear/Off pad.
On models with an OVEN TEMP knob, turn it to OFF.
Open the windows to rid the room of smoke. Wait until
the SELFCLEAN light goes off. Wipe up the excess soil
and reset the clean cycle.
Ovendoor will not open Oven too hot. ° Allowthe oven to cool below locking temperature.
after a clean cycle
Ovennot clean after Oven controls not properly set. • Seethe Using the self-cleaning oven section.
a cleancycle Oven was heavily soiled. ° Cleanup heavy spillovers before starting the clean cycle.
Heavilysoiled ovens may need to self-clean again or for
a longer period of time.
Ovendoor will not Oven is too hot. • Allow the oven to cool below locking temperature.
unlock (on models Donot lock the door with the door latch except when
with a door latch,_ using the self-clean feature.
Self-clean light (on The OVENTEMP knob has not • Set the OVENTEMPknob to CLEAN.See the Using the
some models) blinks been set to CLEANwhen the self-cleaning oven section.
when trying to set a latch was moved to the right.
self-clean cycle
The latch was not moved to the • Move the latch to the right as far as it will go. See the
right when the OVENTEMPknob Using the self-cleaning oven section.
was set to CLEAN.
Self-clean light(on A power interruption occurred. • Turn the OVENTEMPknob to OFFand move the latch
some models) blinks to the left as far as it will go. Reset the range controls
during self-clean cycle to the desired settings. Seethe Using the self-cleaning
oven section.
"Door" appears in the Self-cleaning cyclehas been • Move the latch handle all the way to the right.
display [onsomemodels) selected but the latch handle
was not moved all the way
to the right.
Latch handle was moved to the • Movethe latch handle to the right onlywhen setting
right but a program other than the self-cleaning cycle.
self-cleaning was selected.
"F--" and a number or On models with a door latch, • The latch may have been moved, even if only slightly,
letter flash in the display if a function error code appears from the locked position. Makesure the latch is moved
Ionsomemodels) during the self-cleaning cycle, to the right as far as it will go.
checkthe oven door latch.
You have a function error code. • Touch the Clear/Off pad. Allow the ovento cool for
one hour. Putthe ovenback into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. Ifthe function error
code repeats,call for service.
47

GE EGR2000 Specifications

General

Brand	GE
Model	EGR2000
Category	Ranges
Language	English