GE G005 - Cycle and Additional Options; Automatic Load Sensing

Operating instructions.
Cycle Options
Delay Wash
WhentheDelayWashbuttonis repeatedlypressed,thedelaytimeissetfrom 1(01H)to9 (09H)hoursandbackto clear(00H)hours.Ifyou
pressandholdthe DelayWashbuttonfor] seconds,it willimmediatelyreset.
Fabric Softener
Setthis option to provide a deep rinse or when manually adding fabric softener to the rinse cycle. NOTE:Thisoption is not allowed for some
cycles.When allowed, it may change other settings (e.g.Spin may go to a higher setting) to maximize performance.
NOTE:Do not usefabric softener dispensing balls with thiswasher. Theydo not work correctly in high efficiency washers.
eWash
When the eWash button is pressed, the cycle changes to its most energy efficient settings and all of the eMonitor lights will light to indicate
that the most efficient settings are on. Ifyou change settings, the eWash light will go off and the number of eMonitor lights will decrease (or
increase) to indicate decreased (or increased) energy efficiency settings.
Additional Options
Soak
This option begins with a brief agitation, soaks for a specified period of time, then moves through the rest of the cycle automatically.
Repeatedpressing of the Soak button will add 15minutes, then 50 minutes and then return back to 0 soak minutes.
Extra Rinse
When you useextra detergent or bleach to clean heavily soiled clothes, usethe Extra Rinse option to better remove additional residues.
NOTE:Thisoption isnot allowed for some cycles.
Control Lock
You can lock the controls to prevent any selections from being made. Oryou can lock the controls after you have started a cycle. Children
cannot accidentally start the washer by touching buttons with this option selected.
To lock the washer controls, press and hold both the Soak and Extra Rinse buttons for 5 seconds. Thecontrol lock icon will light up when it
ison.
To unlock the washer controls, pressand hold both the Soak and Extra Rinse buttons for 5 seconds.
NOTE: The Power button can stiff be used when the machine is locked.
Signal
Selectfor an end of cycle signal.
Automatic Load Sensing
This provides the correct amount of water suited to the size and type of load placed in the unit. The washer will not fillwith water
during automatic load sensing ifthe lid is open. When the lid is closed the machine is able to begin filling with water in order to
sense the load size.
NOTE: This is a high efficiency washing machine with lnfusor TM wash action. This system requires less water while providing effective
cleaning action. You may notice that the water level is lower than on your previous washer. This is normal for an lnfusorm-equipped
washer.
Average Small Load Average Medium Load Average Large Load
Clothes Level
Water Level
ClothesLevel
WaterLevel
ClothesLevel
WaterLevel
6