S
Steven FranklinSep 4, 2025
What to do if water won’t pump out of the tub in my GE GD 535?
- SSamantha DodsonSep 4, 2025
If water won’t pump out of the tub, the drain may be clogged. If you have an air gap, clean it.
To Next PageTo Next PageWhat to do if water won’t pump out of the tub in my GE GD 535?
If water won’t pump out of the tub, the drain may be clogged. If you have an air gap, clean it.
What to do if there is cloudiness on glassware in my GE Dishwasher?
Cloudiness on glassware can be due to a few reasons: * A combination of soft water and too much detergent can cause etching, which is permanent. To prevent this, use less detergent if you have soft water and wash glassware in the shortest cycle that will get it clean. * Low-performing phosphate-free detergent. See A white film on glassware, dishware, and the interior in this TROUBLESHOOTING section. * Water temperature entering the dishwasher exceeding 150°F (66°C). Lower the water heater temperature.
How to remove black or gray marks on dishes from my GE GD 535 Dishwasher?
Black or gray marks on dishes are usually caused by aluminum utensils rubbing against the dishes. Remove the marks with a mild, abrasive cleaner.
How to fix spots and filming on glasses and flatware in GE GD 535?
Spots and filming on glasses and flatware can be due to several factors. If you have extremely hard water, use high quality rinse agents such as Cascade® Platinum™ Power Dry™ Rinse Aid or Finish® Jet-Dry® Rinse Aid. Ensure the inlet water temperature is at least 120°F (49°C). Avoid overloading or improperly loading the dishwasher. Make sure your powder detergent is fresh, and refill the rinse agent dispenser with high quality rinse agents if it's empty. Also, ensure you are using the proper amount of highly rated detergent.
How to fix dishes that don’t dry in my GE GD 535 Dishwasher?
If your dishes aren't drying, ensure the inlet water temperature is at least 120°F and select Heated Dry or Dry Boost Normal/High. Check the rinse agent dispenser and fill as required. On some models, you can leave the door closed after the Clean light appears to allow the fan to run for an additional 90 minutes. If using Light/1 Hour/Time Saver cycle switch to a different cycle. Allow cycles to fully complete.
General| Type | Built-In |
|---|---|
| Control Type | Electronic |
| Number of Wash Cycles | 6 |
| Energy Star Certified | Yes |
| Soil Sensor | Yes |
| Stainless Steel Tub | Yes |
| Wash Cycles | Normal |
| Dry Option | Heated Dry |
