– 37 –
Note: The following step will require the use of
a 9/16-in. wrench to hold the tting body while
tightening each of the two 5/8-in. hex nuts.
5. Tighten using 2 wrenches, 1 to hold the tting
body and 1 to tighten each hex nut.
Fitting Body
Hex Nut
Front Ferrule
Back Ferrule
3. Cut the copper tubing close to the tting.
4. Place the hex nut, back ferrule, and front ferrule
on the end of each tube as shown.
Hex Nut
Hex Nut
To Next Page
Loading...
