Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
9
How to Connect the Unicouple
Pull Unicouple and its hoses completely out from
storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
Attach the Unicouple connector to the faucet
adapter by depressing the collar at the top of the
connector. When Unicouple is all the way up onto
the adapter, release the collar. It will then snap into
position to lock the Unicouple in place.
The Unicouple’s small hose carries water from the
faucet to the dishwasher. Its large hose carries drain
water to the sink. Be sure Unicouple is pointing
toward the sink bowl drain opening and the sink
drain is open for water that will drain from your
dishwasher. If your dishwasher drains into a
disposer, operate the disposer until it is completely
empty before starting the dishwasher.
Turn hot water fully on before starting the
dishwasher.
3
2
1
Turn off the hot water.
Release the water pressure by depressing the pressure release
button. This relieves water pressure and protects you, and the
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the
top of the Unicouple connector.
3
2
1
How to Disconnect the Unicouple from Faucet Adapter
To Next Page
Loading...
Need help?
General
