The Problem solver (continued)
PROBLEM POSSIBLECAUSEAND REiMEDY
WATERWON’TPUMP If
the entire bottom of the tub has water, you may have a drain problem. Clean the air
OUT OF THE TUB
gap, if you have one. (See page 19.)
Check the kitchen sink. Is it draining well? Youmay need a plumber.
If dishwasher drains into a disposer, run the disposer to clear. Be sure the disposer is
not clogged.
See the SYSTEMS MONIIXIR (pages 7 to 9).
SUDS IN THE TUB Sudsing detergents are not meant for dishwashers. USE ONLY AUlOMATIC
DISHWASHER DETERGENTS ‘IOAVOIDSUDSING.
To removesuds from the tub: Open the dishwasher. Let suds evaporate. Add 1 gallon
of cold water to the tub. Close and latch the dishwasher. To pump out water, touch
START two times, then immediately touch CLEAR-RESET.
Repeat if necessary.
DISHWASHER LEAKS
Suds can cause unit to overflow. That’s why it’sso important to use a detergent that’s
designed for automatic dishwashers.
Spilling the rinse agent can cause foam during washing. This can lead to overflowing.
Wipe up accidental spill of rinse agent with a damp cloth.
CONTROL PANEL
Shut off power from dishwasher at fuse or circuit breaker. Wait5 seconds and restore
DOESN’T RESPOND
power to dishwasher. Try input panel again.
‘IQINPUTS
If you need more help.. call, toll free:
GE Answer Cente#
800.626.2000
consumer information service
18
To Next Page
