GE gsd2400 - Page 8

The SYSTEMS MONITOR tellsyou if certain things are wrong
KPLAY
WHAT IT MEANS
VVHATTODO
FF
Electrical power has been
IF DISHWASHER WASIN USE WHEN THE POWER
interrupted to the dishwasher but is
FAILURE OCCURRED:
nowback on.
1. Unlatch the door. If the detergent cup is open, add
detergent and close the cup.
2. Relatch the door and touch “START” then immediately
touch “CLEAR/RESET~’ (This will pump any remaining
waterout ofthe machine.)
3. Selectthe desired qcle and rerun the load.
IF DISHWASHER WASNOTIN USE:
L Latch door.
2. Select desired cycle.
3. Run cyclewhen desired.
rt
The dishwasher is taking longer
(_/
This dishwasher is designed toautomatically compensate for
than normal to drain the water out.
longer than normal drain times, but cycletime will be
This is usuallycausedby ablockage
extended. If this code continues to appear frequently then:
inthe drain air gap (seepage 19),a
kink inthe drain hose, or a stopped
1. Clean the air gap (seepage 19).
up drainpipe.
2. Check for a kink in the drain hose.
3. Check plumbing for slowor stopped up drains.
(N~E: W~ty service does not cover household
drain problems.)
r
z
Similar
to blocked drain as
L
Locate and removethe blockagein the drain system as
explained above, but the Z?
explained above. Topump anyremaining water out ofthe
indicates that the drain is so
machine:
cloggedthat the dishwasher cannot
1. Latch door.
continue tooperate in asatistictory
manner. Dishwasher will stop.
2. Select any cycle.
3. Touch “START” andthen immediately touch “CLEAR/
RESET:’ (NOTE: W-nty service does not cover
household drain problems.)
r
3
Dishwasher will not gointo adrain
L
Restart the cycle.If E3 repeats, call for service.
out period. Dishwasher will stop.
r
There is too much waterin the
L~
The dishwasher is designed to automatically pump out extra
dishwasher. If E~ appears after a
water as long as the door islatched. When you hear the motor
power ftilure, this is normal and
stop running:
the dishwasher will correct itself.
1. Unlatch the door and seeif allthe water is gone. (Itis
normal for a small amount ofwaterto remain in the bottom
oftub to keep the water seal lubricated.)
2. If you see water entering the dishwasher, close and latch
the door. Shut offthe watersupply to the dishwasher.
3. If water is gone and no wateris entering the dishwasher,
restart cycle.
4. If Z~repeats, shut off the water supply to the dishwasher.
Call for service.
8
.