EasyManuals Logo

GE GTH18DCDBRBB User Manual

GE GTH18DCDBRBB
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Installation Instructions Mode,78
If you have questions, call 1.800.GE.CARES or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca
BEFOREYOU BEGIN
Read these instructions completely and carefully.
. IMPORTANT-Save these instructions for
local inspector's use,
. IMPORTANT- Observea,,governing
codes and ordinances,
, Note to Installer - Be sure to leave these
instructions with the Consumer,
, Note to Consumer - Keep these instructions
for future reference,
, Skill level - Installation of this appliance requires
basic mechanical skills,
, Completion time - Refrigerator Installation
15 minutes
Reversing the Door Swing
1 hour
. Proper installation is the responsibility of the installer,
. Product failure due to improper installation is not
covered under the Warranty,
WATER SUPPLY TO THE ICEMAKER
(on some models)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line, A water supply kit
(containing copper tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at GEAppliances.com (in Canada
at www.geappliances.ca) or from Parts and Accessories,
1,800,661,1616,
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections,
. Sides 1/8" (3 mm)
. Top 1" (25 mm)
. Back 2" (51 mm)
If the refrigerator is to be installed next to a wall on the
hinge side, allow 5/16" (8 mm) door clearance,
ROLLERSAND LEVELING LEGS
Rollers allow you to move the refrigerator away from the
wall for cleaning,
Leveling Legs near each front corner of the refrigerator, next
to the rollers, should be adjusted if any of the following
OCCURS:
. Refrigerator wobbles due to front roller not being firmly
positioned on the floor,
. Door(s) do not close easily when opened to 45°,
NOTE:
. BEFOREmoving the refrigerator away from the wall,
be sure to turn the leveling legs counterclockwise so that
the weight of the refrigerator is fully transferred to the front
rollers,
. The refrigerator will not be
level from front to back, It will
have a slight backward tilt for
proper door-closing,
To adjust the leveling legs,
turn the two front leveling
legs clockwise to raise the
front of the refrigerator and
counterclockwise to lower it,
__wise to
raise refrigerator
REFRIGERATORLOCATION
. Do not install the refrigerator where the temperature will
go below 60°F (16°C) because it will not run often enough
to maintain proper temperatures,
. Do not install the refrigerator where the temperature will
go above 100°F (37°C) because it will not perform
properly,
. Install it on a floor strong enough to support it fully
loaded,
10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE GTH18DCDBRBB and is the answer not in the manual?

GE GTH18DCDBRBB Specifications

General IconGeneral
BrandGE
ModelGTH18DCDBRBB
CategoryRefrigerator
LanguageEnglish

Related product manuals