GE GUV27ESSMWW - Drum; Drum Removal; Drum Shaft and Bearing

– 29 –
7KHGUXPKDVWKUHHUHSODFHDEOHEDႉHV
Drum Removal
1. Remove the dryer front panel. (See Dryer
Front Panel in this section of this service
guide.)
2. Remove the drive belt from the motor. (See
Drive Belt in this section of this service
guide.)
3. Pull the drum forward and guide it out of the
cabinet.
The drum shaft is attached to the rear of the
drum with three T-20 Torx-head screws. The
EHDULQJFDQEHUHPRYHGE\SXOOLQJLWRႇWKHVKDIW
7KHGUXPVKDIWDQGEHDULQJ¿WLQWRWKHEHDULQJ
retainer in the center of the heater assembly
HOHFWULFPRGHOVRUGLႇXVHUDVVHPEO\JDV
models).
To access the drum shaft and bearing, it is
necessary to remove the drum. (See Drum in
this section of this service guide.)
Drum Shaft
Bearing
Drum 'UXP6KDIWDQG%HDULQJ