GE GWS04HAESS User Manual

8
Care and cleaning.
If the power fails, open the door as
infrequently as possible to maintain the
temperature. A gradual rise in temperature
should not have any adverse effect on the
wine.
If it is extremely hot, you may want to unload
the wine from the wine center and move
the wine to a cooler location until power is
restored.
The controls may maintain your temperature
settings when the power has been restored. If
your settings are not correct, reset according
to the Control Settings section.
In the Event of a Power Failure
Unload the wine, then secure the racks by
taping them in place to prevent damage.
Be sure the wine center stays in an upright
position during the move.
Preparing to Move
Replacing the light bulb.
Unplug the wine center.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the wine
center near the back. To remove the light shield, remove the screw on the
right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Unscrew the light bulb from the socket.
Replace with a 15 watt, 120 volt bulb. This type of bulb is available at most
hardware and automotive parts stores.
WARNING: Using a bulb rated higher than 15 watts may
damage the electronic controls on the wine center.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the wine center.
Light Shield
Screw

GE GWS04HAESS Specifications

General

Type	wine cooler; freestanding
Size	compact
Color	black; stainless (with black case)
Total Capacity	4.1 cu. ft.; 30 wine bottles
Bottle Capacity	30 bottles
Defrost System	automatic
Undercounter	yes
Racks	6
Temperature Zones	single
Temperature Control	yes; digital
Interior Light	yes
Control Type	electronic; led
Child Lock	yes
Electrical Requirements	120v; 60hz; 15a
Voltage	120 volts
Current	15

Weight and Dimensions

Depth	22 1/2 inch
Height	33 inch
Width	18 7/8 inch
Net Weight	72 lbs.