16
Programming the Water Softener.
e
When the transformer is plugged into the
electrical outlet, a model code and test number
(example: J3.4 & F30) are shown in the display.
Then, “12:00 PM” begins to flash. An arrow
is
displayed next to CLOCK on the face plate decal.
CONTROL OPERATION:
&21752/6(77,1*65(48,5(' upon initial
installation and after an extended power outage.
8VHWKHMODE/SET button to scroll arrow to
desired control function set.
$IWHUWKHPRGHLVVHOHFWHGXVHWKH83
and
DOWN
buttons to change the settings of the
control.
3UHVVWKHMODE/SET button to accept changes.
$´EHHSµVRXQGVZKLOHSUHVVLQJEXWWRQVIRU
control programming. One beep signals a
change in the control display. Repeated beeps
mean the control will not accept a change from
the button you have pressed, and you should
select another button.
SET TIME OF DAY
1. Press MODE/SET button until the arrow
points to CLOCK.
2. Press the UP
or DOWN buttons to set
the present time. UP
moves the display
ahead; DOWN
sets the time back. Be sure
AM and PM is correct.
NOTE: Press buttons and quickly release to
slowly advance the display one number at a
time. Hold the buttons down for fast advance.
3. When the correct time is shown in the display,
press MODE/SET to accept.
Salt Level
Clock
Hardness
Recharge
PM
To Next Page
Loading...
Need help?
General
