Service.
Before you call for service, review the detailed troubleshooting tips in the Owner's manual, If needed, service can be scheduled
by visiting us online GEAppliances, com or calling 800,GECARES 800,432,2737, In Canada visit GEAppliances, ca or call
800,561,3344,
Truth or Myth?
The automatic ice maker in my
refrigerator will produce ice when the
refrigerator is plugged in to a power
receptacle.
Iwill never see frost inside the freezer
compartment.
Answer
MYTH
MYTH
Refrigerator door handles can be TRUE
easily tightened.
After starting the ice maker throw TRUE To avoid issues with odor and taste the first batch of ice should be discarded
away 24 hours of ice production.
Door removal is always required for MYTH Doors should only be removed when necessary to prevent damage from passage
installation, way or access to final location. If doors are removed please review Reversing the
Door Swing section for re-hang procedure.
There is an adjustment to rear wheels. MYTH Front leveling legs are adjustable and should be used to balance the refrigerator.
Leveling legs are used to make initial fresh food door adjustment. There should
be approximately o 1A"fall from the front to back to ensure that the doors always
close.
Any All-Purpose cleaner can be used to MYTH
clean my refrigerator.
Gaskets will last longer with regular
cleaning and maintenance.
TRUE
Explanation
The refrigerator must be connected to water, and the ice maker must be turned
on. Make sure the ice maker is turned on, only after the water line is connected
and water is turned on. The ice maker can be turned off by switching it to the OFF
position.
The freezer must be 15 degrees or colder before the icemaker will produce ice.
Please allow at least 24 hours for the refrigerator to pull down and the unit's
temperature to stabilize,
Frost inside the freezer typically indicates that the door is not properly sealed,
or has been left open, If frost is found, clear the frost using a plastic spatula and
towel, then check to ensure that no food packages or containers are preventing
the freezer door from closing, To help reduce to the potential for frost please make
sure there is proper clearance to the air supply and vents in the freezer to improve
circulation, Always cover food before loading into the refrigerator, moisture from
open containers can add to the frost load,
If door handles are loose or have a gap, the handle can be adjusted with set
screws located on the ends of the handles,
Doors may be shipped with protective TRUE
film that has to be removed before
use,
Have more questions? For more information on your refrigerator or other GE appliances please visit
www.geappliances.corn/videos
All-purpose cleaners are not recommended for use on the refrigerator.
Do not use wax, polish, ammonia, bleach, or other products containing chlorine
on for any surfaces. Clean with a cloth dampened with soapy water. Dry with a
soft cloth. The stainless steel doors can be cleaned with a commercially available
stainless steel cleaner. Cleaners with oxalic acid such as Bar Keepers Friend
Soft Cleanser TM will remove rust, tarnish and small blemishes. Use only a liquid
cleanser free of grit and rub in the direction of the brush lines with a damp soft
sponge. Do not use appliance wax or polish on the stainless steel.
Clean gaskets with warm soapy water. Make sure all folds are clean and dry after
cleaning. Make sure flanges are clear of any grit or grime. After cleaning the door
gaskets, apply paraffin wax or petroleum jelly to the door gaskets and hinges
at the hinge side. This helps keep the gaskets from sticking and bending out of
shape.
Smooth finished doors (Stainless, Slate, Gloss Black end Gloss White, or Silver
Metallic) will have o clear plastic film on the door that must be removed after
install.
16
To Next Page
Loading...
Need help?
General
